will they fit?

[agilecanon]

hey all, wanting a set of alloys and came across these on ebay, tempted to make an offer for them as they're close enough for me to go get them, only was after some 14''s so not to mess with anything but these look appealing, but need your experienced knowelege as to wether they'll fit straight on without any further modding, they're for a k11 98 reg 1.3 if that makes any difference
http://cgi.ebay.co.uk/4-x-15-Momo-a..._tyres_Rims_Car_Wheels_ET&hash=item20b5aef2ed
cheers guys

 

[pollyp]

ask the guy to check the centre bore diameter is at least 58.8mm

 

[mckenziecz]

ask the guy to check the centre bore diameter is at least 58.8mm

its 59.1. isnt it?

 

[pollyp]

the centre hub surface measures at least 58.8 dia so as long as the holes at or bigger than that

 

[mckenziecz]

the centre hub surface measures at least 58.8 dia so as long as the holes at or bigger than that

are you sure about it? I got 59.1mm spigots and they are proper snug fit

 

[frank]

that extra 1/2 a mm ish is clearance so that the nut tapers do the centraling aint it (proving that the centre bores do sweet FA regarding support/balance :glare

 

[markbognor]

Yeah I'm calling 59.1 too.

 

[Eliot]

http://www.micra.org.uk/threads/21897-Centre-Bore-Alloy-Wheels

yeah 59.1

 

[agilecanon]

thanks for ur help guys, just recieved a reply from the seller, the wheels are apparently about a 54 bore, (taken with a measuring tape lol) so gotta keep on searching, so the centre bore is definately 59.1 for the micra k11? big bore considering the size of the car, bit reasuring though:grinning:

 

[Scott]

Yeah Micra is 59.1

 

[agilecanon]

cheers

 

[pollyp]

if the wheel bore is too small, you could get it machined larger to fit but that'll add costs

 

[mintyfresh]

if the wheel bore is too small, you could get it machined larger to fit but that'll add costs

Mine were about 4mm too small so I got the bore enlarged, cost about £40