1.0 to 1.3 conversion

[CMF_little red]

hi, this is my fisrt thread as i hav just bought a mint condition (altho prob the lowest model possible, no extras)
k11 and i want to covert it from a 1.0 to a 1.3 its an s reg late 1998 (pre coil pack). i want to know if i need to swap everything, g/box, shafts, loom, ecu ect or will the 1.3 engine match up with the 1.0 box and will my original loom match the 1.3's injectors, lambda sensor, alternator ect, basically im looking to find out which is the simplest route to go down and any problems im likely to occur along the way as this is my first engine conversion, any useful imformation welcome, thanx

 

[CMF_frank2]

you only need to change the engine little red, plug and play

 

[CMF_little red]

thanks frank, if the worst were to happen after the swap, do u think the insurance ppl would b able to tell and void my claim? am i better declaring it?

 

[CMF_little red]

also meant to ask, which clutch, flywheel assembly would i go with? are they the same? thanks again

 

[CMF_frank2]

the pre-facelift 1.0 has a smaller f/w clutch g/box shafts etc mate, and the facelift 1.0 f/w is a bit lighter than the 1.3.
so use yours eh
and the engine code is somewhat visible eh

 

[CMF_little red]

cool, any ideas where i can find a CG13DE engine in good condition? or am i better to just buy a 1.3 micra thts failed it mot?

 

[CMF_little red]

oh another thing, my micra has NATS will this affect my engine swap in anyway?

 

[CMF_frank2]

little red WROTE:

"oh another thing, my micra has NATS will this affect my engine swap in anyway?

no, the nats is in the ecu mate, and decent cg13,s can be hard to find really

 

[CMF_Martos]

Was I just looking at this on Autotrader?

 

[CMF_little red]

aye, i just bought it, its a minter