S sjw102 Jan 28, 2011 #1 hi i dnt ave k12, but a k11. however my m8 does so am asking on behalf of him, how do u go about removing the rear drum, do u have to remove the hub bolt in the middle, or does it jus pull off lyk the k11? hes got a micra s. 03 thanks
hi i dnt ave k12, but a k11. however my m8 does so am asking on behalf of him, how do u go about removing the rear drum, do u have to remove the hub bolt in the middle, or does it jus pull off lyk the k11? hes got a micra s. 03 thanks
frank Club Member Jan 28, 2011 #2 they,re screw-in wheel studs eh, so yes, you will have to remove the hubnut
frank Club Member Jan 28, 2011 #5 sjw102 said: u no wat the torque settin is frank? Click to expand... there is a k12 pdf around to download somewhere, but if they are taper bearings then just a light preload only eh
sjw102 said: u no wat the torque settin is frank? Click to expand... there is a k12 pdf around to download somewhere, but if they are taper bearings then just a light preload only eh
OP OP S sjw102 Jan 28, 2011 #6 aye, jus t tek the play out of the drum init, nd thx frank, wasnt sure cause i fix wagons not cars!
frank Club Member Jan 28, 2011 #9 sjw102 said: rite thx frank, nd thts tight tht 4 a car Click to expand... yeh-man :grinning:, i always use a 3/4 drive breaker bar on mine
sjw102 said: rite thx frank, nd thts tight tht 4 a car Click to expand... yeh-man :grinning:, i always use a 3/4 drive breaker bar on mine
