Hi guys I'm all new to this but iv been trying to build my micra to rally standard but iv bought 3 lots of alloys and they all are 4x100 and fit but when it comes to going over 40mph the car moves and it seems the bores of the alloys are to small by mms can someone help cheers
Alloy problems
- Thread starter NissanMicraRallyboi
- Start date
OP
OP
Spigots could be the answer to my problems for the rear but I wouldnt beable to fit them for the front as the front hubs are to big for the alloys iv tryed
drand
1st Micraversary!
If the hub is too big for the centre bore of the wheel, open the wheel centre out using a drill and a flap wheel. If it's only a mm or two it'll do the job no problem.
Spigot rings effectively make the hub larger diameter so it fits the wheel centre bore.
Wobble nuts let you adjust for very slight pcd variations (98 on a 100 etc).
Spigot rings effectively make the hub larger diameter so it fits the wheel centre bore.
Wobble nuts let you adjust for very slight pcd variations (98 on a 100 etc).
OP
OP
Okay cheers for the advice lads
