Search results

Hi all While removing some of the connectors, this little git snapped on me, there are two connectors on the right hand side of the head, bigger one a blue colour then there is this one, a smaller connector. Just wondering what this is, easy to repair or replace? Cheers

After completely stripping engine bay apart from necessities, i just wondered where these pipes should actually go and whats the best thing to do with them. Seem like breather pipes 2xPipes- go to the back of the inlet, 1 of them joins up in a connection with a pipe that goes to the servo. The...

Ok had a little run for the first time since HG change and few other bits done in the track car(see other posts) When flat out in 1st it seemed to drop revs then pick back up again half way through ( tryd to make a vid of it but again not to sure if you can hear what i mean) Any thoughts Cheers

Hi all Purchased some magnecor kv85 performance leads a few months back, just wondering peoples thoughts on the leads themselves and a quality spark plug to go with these. Car is a 1.0 Cheers

Hi guys just wondering if this would have any benefit to performance, iam assuming it will due to air flow, just wondering what thoughts you guys have, Pics shows the honeycomb cleaned out of the CAT that meets the manifold

Update Started up first time today, idled well and revved ok (didnt take it to high) warmed up to temp (can only tell by feeling pipes) sounded ok too. Only thing bothered me was the residue in behind oil filler cap (could just be moisture?) Oil got a little milky on dip stick- but thinking...

Wondering if anybody could post a pic of the gaskets needed for injectors on 1.0 for re-fitting, i didnt remove the injectors and struggling to find anybody who sells just the seals. Thanks in advance

Hi all After reading through some of the different post relating to my job at hand, i have seen that if i change my head gasket and skim the head (if i can due to the racing regulations i face) that the cams will need to be advanced. Is this correct? If so how is that done, will a timing tool...

Hi all New to the site and need a little help.. While stripping the engine down for a new head gasket and possible work done on the head, i flipped over a washer where the head bolts go, manual says take note which way they go in, after looking at the others i cant really tell the difference...