Search results

  1. C

    Bosch coilpack Maf sensor wiring

    Hi, hoping for some help here. My coilpack micra 2001 keeps randomly cutting out. It won't pull strongly, especially when cold it has huge flat spot. There are no air leaks, and I've tested the throttle position sensor, which is fine. I would like to test the Maf sensor using a multi meter, do...
  2. C

    Throttle position sensor help Bosch coilpack

    Hi all, looking for some help with Tps plug. I unplugged the Tps connector which has 3 wires the centre wire is the earth, but the 2 wires either side are reading 5 volts on my digital multi meter. Not sure why this is??. Any advice welcome, thanks in advance.
  3. C

    Sagging door hinge

    Hi all, I need some advice on repairing my sagging drivers door. There was an explanation from .... Frank.. I think. To use a plank of wood under the door and sill and lever the door up. My question is do I loosen the door hinges first, otherwise how would it work..... Any body tried this...
  4. C

    Rear sill protection

    Hi all, we all know the k11 has a problem with the rear sills rusting from the inside out. Mines a 3 door and I sat in the rear and removed the inner plastic panel, you can then see the inside of the rear sill. I gave it a spray on both sides with some ACF 50. Only took half an hour. I thought...
  5. C

    Engine management light

    Hi all, went to my k11 1.0 2000 model this morning and it wouldn't start, orange engine light was flashing. I pulled out the fuses for ecu to check if they had blown, bit of a wild guess, they hadn't, when I replaced them the car started and runs fine...... Either a loose fuse / bad connection...
  6. C

    Fitted new thermostat

    Hi all. I've fitted a new thermostat today and cannot believe the difference, the car warms up much much quicker, and the heater is much hotter .Best £6 I've ever spent on the old girl.
  7. C

    Remove rear inner panel on 2door model

    Hi all, some low life has dented the rear panel on my two door facelift 1.0. It is dented just in front of the rear wheel,so I need to remove the inner panel in the rear of the car so I can hopefully push the dent out. Any idea how it comes off anyone please ...??.
  8. C

    Oil anti drain back valve

    Hi all, having a problem with my k11 1.0 . I've changed the oil and filter twice, but if the car is left for more than a few hours ,the engine rattles while the oil light stays on,maybe 2 or 3 seconds . I am convinced that the oil is draining out of the filter . I have got 5/30 oil in so its not...
Back
Top