Search results

Does anyone have a picture of the idle adjustment screw on the throttle body for a 1.0l non-coilpack K11. I just need to make a slight adjustment as it is 400rpm above what it should be

I have a '96 non-coilpack 1.0L LHD car so need parts that are compatible with this model. I have heard the 1.3l cams are a straight swap for the 1.0l engine. The manifold should be no problem and the blower motor on my car makes a bit of a squeaking noise. Blower is located on the RH side of the...

Over here in Germany I can buy 102RON fuel at the pump. If I was to advance the ignition timing, what would be a safe level to advance it to and also how much BHP could be gained in doing so? Just thought I'd add: I will still be retaining the OEM ECU so it is purely ign adv that I have any...

As per the title really, I have heard these are a straight swap so if anyone has a set knocking about please let me know;)

I fitted a clock set (RPM tacho) from a Super S last night to my 1.0L and they all work fine apart from the backlit function isn't working. Is there a fuse for this or are there individual bulbs for each gauge? I just find it strange that none of the gauges light up and as I didn't finish...

Anyone ever had this problem before; basically after reversing a few meters the LH rear wheel just locks up on its own accord, as though the handbrake has been applied. If I then pull forward it locks up again and can take a good 20meters or so before the wheel rotates again. I have loosened of...

According to Ebb's thread the 1.3l cams are a straight swap into the 1.0l with an instance 5bhp or so; is this the case? And if so, what do they cost and where can you by them?

Ok guys, I have finished installing my new engine today and whilst the engine was out I decided to do a little tuning to make it a little more interesting; basically along the lines of the "EBB Mirco Micra" thread as per the following. New engine going in: Cut up old HT leads to use some...

I'm just re-fitting a new engine in my 1.0l '96 and cannot remember where the black/yellow main earth lead connects to (the one which starts underneath the battery tray)?

Hi guys, whilst reading the Maxi Micra thread it was mentioned that the clockset was replaced with a set containing an RPM gauge (where the water temp normally is on the left). I have a 1.0l '96 model: is it a straight swap for a set of dials with the RPM gauge ones or do they need re-wiring et...

As my gear lever doesn't centre I had great pleasure in reading a fix on this site; however after removing the central exhaust shield I was so disapointed to find the spring perfectly intact. Does anyone have any other ideas as to what can potentially cause this problem.

Does anyone have any before and after pictures for lightening a flywheel from a 1.0l K11. I am going to attempt to do this tomorrow and just want to see where everyone is reducing the weight from.