wheel question

[ash 101]

this has probably been asked 20.000 times before but would k11 wheels fit a k10? and does the it make a difference if the k11 is an sr?

 

[joesouthgate]

Yes they will fit. pcd 4x100 on all micras can't remember offset but theyre the same anyway

 

[ash 101]

thanks for the info

 

[joesouthgate]

no probs

 

[Speedle]

offset is about 38 but yeah k11 wheels will cause no problems what-so-ever

 

[SammoHung]

what about the centre bore? (K11 wheel versus K10 hub?)

 

[sonic]

the same.

 

[Arnold]

Ems put K11 wheels on her K10, guaranteed 100% fitment.

 

[SammoHung]

Yeah thay're on and the stud pttern is exact but im not sure about the center bore...I havent properly measured yet but on inspection it 'looks' like the centre bore of the K11 (alloy) has a taper...and the inner side of the taper looks smaller than the K10 hub center but the outer looks bigger

See my dodgy sketch atached

I havent measured this yet though so I could just be paranoid...

 

[Arnold]

Did the silver bullet come with Alloys Sammo? as they were from a K11.

 

[SammoHung]

Did the silver bullet come with Alloys Sammo? as they were from a K11.

Yeah, and they seem to be running absolutely fine!
NO PROBLEMS WHAT SO EVER dirving-wise

but the sketch above does refer to those wheels (but I havent measured em yet though

 

[hissyfizzy]

I now have k11 13's on the pig as the 12 inch gave no cornering