Hey guys, so, the engine has been stripped and painted etc! I have a small problem, the engine timing, because ive removed all the pulleys etc i have no idea how to get the engine back to normal again! So far ive aligned the pistons so that #1 cylinder is at TDC, all i need to do now is align the camshaft! Any ideas or previous posts at all?! Or is it trial and error?!
MA10 engine timing
- Thread starter hoverbover
- Start date
hi
Ill have to have a closer examination but i cant see any marks!
Ill have to have a closer examination but i cant see any marks!
my haynes manual is on the way, Baz is right, buy one 
here is one page from PDF which should help
http://tinypic.com/r/2zghi5l/6
here is one page from PDF which should help
http://tinypic.com/r/2zghi5l/6
Baz
Ex. Club Member
Dirty. . .Filthy but good advice all the same lol
Ok i have found the timing mark and spun the engine over a few times and hurt my ####ing finger in the process!!
So all is well so far, once she is done ill get some pictures on the forum!
Next job is timing!!!!!
So all is well so far, once she is done ill get some pictures on the forum!
Next job is timing!!!!!
