Jack the front off car away up undo 2 spring loaded bolts put a bit off boxsection up in2 cat and harmmer the end off it p/s ul need safety glass's lol the front cat has near a inch off honey comb like crap in it holding gases back car seems sharper after I done this tho u don't notice it as...
Has eney one thot bout building 1.0gears in2 1.3 box so you can keep bigger 1.3 clutch as I have 3 clutched in in 2 mounths there ripping the padding off the clutch plate it's self good job theres 2 year warranty on it lol
I made one but a 3" rolld tail piece off ebay £15 I cut standard box because that's a rail hard bend 2 match that goes over the axel so that's why ur best to cut standard box if ur micra doesn't have cut out on bumper cherry bomb not much good plus wb hangers am in Ireland are I'd sell u mine it...
There's a small block connecter taped onto the loom behind the d/s tail light I got a factory parcel shelf out off breakers that's how I no bout it I couldn't believe it I was gona run wires up too
Stickers-lol
Ok remove front spring loaded bolts below front filter move exhaust 2 the side beat the inch deep filter out off inside off manifold filter- keep eyes away stuff like fiber glass in side it then bolt it back up agean car will rev out better then make a streat back-pipe/box
Scaffolding pole-i like that one I yoused trampoline poles they click to gether then weld round them plus you have bends + I knocked the filling out off front manifold cat lets it rev clearer I got a 3 half inch roled stainless tail piece off ebay cheap and it fits nice in2 bumper and car bangs...