Search results

Were are u In Ireland and in north

Jack the front off car away up undo 2 spring loaded bolts put a bit off boxsection up in2 cat and harmmer the end off it p/s ul need safety glass's lol the front cat has near a inch off honey comb like crap in it holding gases back car seems sharper after I done this tho u don't notice it as...

Has eney one thot bout building 1.0gears in2 1.3 box so you can keep bigger 1.3 clutch as I have 3 clutched in in 2 mounths there ripping the padding off the clutch plate it's self good job theres 2 year warranty on it lol

When u say dash u mean hole thing or clocks area

Gun metal gray with matlic flake added in2 it

I made one but a 3" rolld tail piece off ebay £15 I cut standard box because that's a rail hard bend 2 match that goes over the axel so that's why ur best to cut standard box if ur micra doesn't have cut out on bumper cherry bomb not much good plus wb hangers am in Ireland are I'd sell u mine it...

There's a small block connecter taped onto the loom behind the d/s tail light I got a factory parcel shelf out off breakers that's how I no bout it I couldn't believe it I was gona run wires up too

Put on lights and move wires about I'd say n/s light wires infront off battery ul see a bit off a loom there were the lights cum out

Long shot but make sure u haven't hit below and ur heat shield is agents ur gear linkage

What is ment by cg10 is engine number as in cg10=1.0 and cg13=1.3 this number is on the block below the water hose beside the gear box

Hi il try an answer u right the the engine ur puting in if it's none coil pack 1 it will fit no probs if there both cg10 distribute

1100 bike 4branch being made for micra

Stickers-lol Ok remove front spring loaded bolts below front filter move exhaust 2 the side beat the inch deep filter out off inside off manifold filter- keep eyes away stuff like fiber glass in side it then bolt it back up agean car will rev out better then make a streat back-pipe/box

Buy 65mil studs off ebay ur standard studs r 40mil so that leaves u 25mil for spacers rear so easy removed and fitted

Scaffolding pole-i like that one I yoused trampoline poles they click to gether then weld round them plus you have bends + I knocked the filling out off front manifold cat lets it rev clearer I got a 3 half inch roled stainless tail piece off ebay cheap and it fits nice in2 bumper and car bangs...

98-99 front lowering springs just need a inch off the top off them and the click into strut top

That micra thing on ur link would make u sick wouldn't mind the 2 corners off the front bumper 2 put on mine but middle would have to go

Check the sand plate behind the disc then way the wheel on grab it top and bottom and c if there eney play ul need a 32 r 34mm shocket to check center nut

I got a small middle silencer cut off back box beat 1 off 3 triangler baffles 2 the side in put a 3half inch rolled t/pipe on when the car heats and u let off the throttle it back fires it's class and when mot comes I can just unbolt it and put spare back box on

I wouldn't go 2 transmission place they il charge u for 100 pieces ud never need jack car put axle stands in put in gear let clutch out and listen below 2hear were the noise is