Search results

  1. E

    Knuckle bearing damage - can replace with K11 knuckle?

    Hi there. During past few days I've noticed whirring sound coming from front right wheel, in speeds higher than 15 mph. I supposed, that it wasn't the CV-joint, because it should click (not whirr) in hard turns (and it did, but only slightly). Yesterday I bought and replaced the CV-joint, to...
  2. E

    alterantor sounds like angry cat

    alternator sounds like angry cat hi guys, i am having problems with an alternator.. in fact, with two of them. original, 24 years old alternator in my k10 stopped working few days ago. well, not completely, it produced some juice, but not enough. while idling, i read 13.00 volts on...
  3. E

    part of the ignition key stuck in

    hi.. my ignition key snapped in half, one centimeter of its length is stuck in the ignition box.. when i insert the other half of the key, i can start the engine.. as a bonus, it is possible to remove the key while the engine is running is there any way of getting it out? i have very thin...
  4. E

    Old 1.2 MA12 - problems getting it up and running

    Hi guys.. i've got an old, 5 years sitting still micra in a garage, it has MA12 engine with electronic igniton and ECU unit under passengers seat (3 connectors, size approx 15x20cm) thought i would fire it up and get out of the garage.. then give it to one of my friends, (i used it for...
  5. E

    Egres's K10

    Hi, to cut long story short, i bought my Micra a year ago. It ran, but there were lots of issues with dizzy, carb, well.. almost everything.. I managed to repair everything while using the car every day (I hope :D) with great help of you all and spent last few months doing smaller things...
  6. E

    rear lights LED mod

    hi folks, been there for a few months, spend most of the time looking for help and reading older topics about carb issues etc.. now when the car is finally running fine, i've decided it is a good time to add something extra to it. i have a problem with lights. front lights (=driving...
  7. E

    Oil pressure switch thread size

    Hi. Bought oil pressure meter and after troubles with M10 sized sensor and m12 thread in engine block for water temp gauge i thought that this time i will ask first. Do you know what thread size is the oil psi sensor? Thanks in advance
  8. E

    breaker points... just messed up, or really ****** up?

    hey :) finally got to check the points in my not-that-reliable dizzy.. what do you say? fwn they look a bit.. worn :glare:
  9. E

    car revs after lifting throttle, only under load

    hi again, i am sorry that my thread is again about problems, but problems are to be sorted :) when i start engine and rev it, it goes back to idle fine. when it has proper temperature and i do whatever i want with throttle on neutral or clutch, goes back to idle fine when the engine...
  10. E

    should i change headgasket? // problems in the future if i do not

    should i change headgasket? // problems in the future if i do not // videos hi guys, I'll jump right into it: My micra k10 '86 1.0L with 222222,2 km done last week has problems.. again.. Maybe some of you remember my thread with distributor - stuttering under high load. I've replaced...
  11. E

    stuttering under high load, maybe distributor?

    stuttering under high load, maybe distributor? // DONE: dirty carb Hi, i bought K10 two months ago. During those two months i kinda got together with it, slowly discovering it's weaker spots. It has it 1.0 (988cc if i am right) engine, year 1986, approximately 218000km done (135500 miles)...
Back
Top