Recent content by sedicirich

Thanks Pollyp, thats what I will do to even the travel on the pedals. They have been bled correctly now so I think I will leave them on.

Hi All, after much messing around I finally fitted the sunny Gti brakes I bought from a chap on here years ago. They needed 15mm spacers to clear the wheel with longer studs. My pressure bleeder did not fit the resevior so use the 2 man approach to bleeding. Not convinced they have bled...

If its a 600 then you need to set the rev limit with the software. Note about the shift light, it mush have a resistor on it as the board leaks to earth and appears to be on all the time if you don't. Omex told me the value to use. To run only need crank signal and TPS or MAP sensor. Temp...

They say Gti on them which I assume the breakers must have put on them. Yes I have 1mm spacers on them, but thats not the issue. The issue is the spokes of the alloy touch the front of the caliper, they are fine with radial clearance, just need about 2 mm more offset, niether the 100nx or Std...

Hi guy's I know this subject has been around for a bit, but I see most people have an after market wheels with their brake conversions. I have just tried to fit the calipers on my wife's 51 plate K11, the brakes fit ok, but the steel wheel does not clear the caliper (14"), I bought some 100NX...