Recent content by petros047

I have 99 model micra k11 with 13/70/155 tires I have buy 14" rims from 2000 face lift model. My question is what is the correct tire size who I must use ? My micra is 1.3 with 1.3 transmission and ecu. I ask a local tire seller and told me that the closest size is 165/55/14. I search the...

Maybe I am confused as you said and my micra have from manufacter alarm system. So I have to ask Dealer in Greece about wiring of this alarm

Hello My micra have from manufacter nats security system. I have disable the system ,turning the key to off, because the remote control didnt work well. It is possible to complete remove the nats cpu located to engine bay and install a third party alarm system? Or I have to rewire the new alarm...

for the big wire ground ok I understand the little is with female clip I can not foumd were. the pics will help a lot thank you

Thank you very much and the second little clip with ground?

in the place were the possitive cable go? I have to unscrew a bolt and fit them there? also I can not found the clip to connect the liitle ground is on the motor too?

I replace my engine and now I dodnt remember were this ground connect to.

I have the same problem first i replace thermostat with no luck fan radiator work perfect but the temperature rise when the car run with load. unfortunately the engine burn engine gasket so I buy new motor. So try to resolve the problem in a garage and dont test it on road.

I found this schematic http://www.micra.org.uk/attachments/k11-wiring-nats-jpg.17005/ and if I understand well the black wire go to ground and the other to ecu pin 43 My car didnt have this wire so I have to add new direct from ecu to oil pressure sensor

I mean power steering wheel system and the connector probably is from oil pressure steering wheel

I have buy complete hydraulic kit in order to replace my old mechanic. Everything fit fine but I dont know were to plug the 2 wires from the sensor who hydraulic unit have. Can someone help?

After that the engine will work with old ecu and distributor ? Or with new coil pack and new ecu? Also the transmission is the same? Or I need gearbox for ga3d?

I have found a cga3d engine complete with ecu , coils,harness. It is possible to make the swap? Or I will need and new transmission or anything else? Thank you

Hello I have finish my swap from cg10 to cg13 and I would like to install and cg13 ecu. I found 2 types the bosch ecu and the nissan ecu what type to use? Also I have to sync the new ecu with my key so it is critical to make a correct choice. My micra from factory have nissan ecu

Just a logic question if the ecu is the same why nissan have different part number? Or maybe the ecu from cg10 work fine with cg13 but the cg13 ecu have different maps for better fuel consumption timing on load etc