Recent content by Chops

not happy my tutorial has been taken down, i put time and effort into that, no matter how it seemed to whoever removed it

haha derp, tired lol. thats a shame, ill just have to find out for myself. as long as it runs at all its fine to mess about with i suppose, cheers!

you reckon just raising the fuel pressure would deal with it?

how about an engine skim/flat tops, do higher compressions suit itbs?

SAFC?

all through the revrange? or did it change as it went higher?

exhaust is easy, but cams would be a bugger to source with no budget

with a bit of port matching and whatnot, ittle make more power over stock wont it? cant the stock injectors cope much further than stock?

That single itb plenum is what i meant. could we expect to see gains from a setup like that?

Hey all, just been talking with a mate about his micra, and we wanna fit bike carbs/ throttlebodys on a tight (non existent :L) budget. the idea is to chop up a standard intake mani leaving the injectors in place and weld/ fix itbs from whatever to it with a throttle position sensor retrofitted...

yer i though you could fit the longer rods in too. i made a mistake it seems.

hang on, just been reading through this and now im confused. the plan i had was to buy a 1.0 and dump 1.3 crank and cams in, but now it seems that wouldnt work? id need to fit 1.3 rods in too?

this is annoying, ive got a prefacelift 1.0 flywheel here that i lightened down to 5kgs ish and sandblasted. could have sold you it if id seen this thread

this was my plan, i cant see any reason why it wouldnt be a resonable method, tho getting those pistons back in through the bottom of the engine would be a messy job lol, plenty of hands needed there id say.