Recent content by barrysheen

  1. barrysheen

    ECU OR MAF/TB OR O2SENSOR/OR NEEDS TEMP SEN MOD ?....... on k11 1.0 1994

    HELLO people im new on this site and got crap spelling. I own an k11 1.0 1994, and i am planning on keeping it and maybe putting a bigger lump in it in future, with these k11s being very light an all it should be a good gti eater from the lights LOL. Anyway trying to get familiar with it and...
  2. barrysheen

    volt readings

    hello frank, when you say lamda sensor, is that same as o2 sensor,the one just above the cat?:)
  3. barrysheen

    volt readings

    hello frank thaks for your reply,it also has slight hesitation also, i know this is very common with a micra but its driving me bonkers,almost feels like the engine mounts are gone also. If you plod alonge say at about 2000revs and let throttle off an on its very all or nothing, seems like its...
  4. barrysheen

    volt readings

    Hi, it’s barrysheen here. New to all this forum stuff. Can you help me with the following ? What are the voltage and resistance readings for a nissan micra 1.0 K11 1994, for the throttle body/maf TPS sensor, the idle control sensor, the O2 sensor, the destributor etc and what voltages should I...
  5. barrysheen

    voltage readings

    Hi, it’s barrysheen here. New to all this forum stuff. Can you help me with the following ? What are the voltage and resistance readings for a nissan micra 1.0 K11 1994, for the throttle body/maf TPS sensor, the idle control sensor, the O2 sensor, the destributor etc and what voltages should...
  6. barrysheen

    need help with micra k11 1.0 1993,

    need help with micra k11 1.0 1993,
  7. barrysheen

    Fuel Pressure - Micra 1.0 LX K11

    sorry i ment would nearest dam it 5 psi lower pressre at filter than standard, do you think this would cause this or not? maybe air mass flow?, the element was glowin like a bulb when these probs started,it isnt now. would really appreciate some help anyone, thanks
  8. barrysheen

    Fuel Pressure - Micra 1.0 LX K11

    m y fuel pressure was 2.2 bar with vacume pipe on today. i had check it cus my micra i.0 k11 is spittin an splutterin above 2500revs an up2 that point it holds back like fuel starvation. Would 0.3bar lower than standerd amount in fuel presser cause these probs?
  9. barrysheen

    hello, my name i go under is barrysheen. im lookin for good advice.

    1992-93- wonder if i could just put a standard carb on from a k10 an unplug wires frm injectors? would that fit ?
  10. barrysheen

    hello, my name i go under is barrysheen. im lookin for good advice.

    got bad engine symptoms on my micra 1.0 k11, it suddenly stopped tickin over an runnin rich afta i put some injector cleaner in fuel day b4,an5 mins afta i sprayed maintanace spray into air inlet. It would stil pull ok through revs,though it was a bit splutery.It kept these symptoms for...
Back
Top