Search results

Hi Guys, Is the dizzy flywheel compatible with the coilpack gearbox / starter motor setup? As in is the offset of the ring gear the same across both flywheels? I dont have any to hand to check & do not need the crank sensor ring of a coilpack flywheel as the trigger wheel inputs taken from the...

Hi guys, Looking for a pair of fuel tank straps, K11. Cash waiting & would need to be posted please. Thanks

Hi Guys, Can anybody tell me the bolt diameter for the rear ARB mounting to the body?

Looking for any wide track parts: Bottom arms, arches, axle etc

Hi guys, been a while since i've been back on here! Got hold of a K11 coilpack for a cheap daily (never dealt with the CGA much) and its gradually gotten worse and worse to the point now its hunting on idle from about 500rpm to 2000rpm! MAF sensor was supposedly replaced last year & there's no...

As title looking for a Gripper diff in tarmac spec. Thank you

Wanted: T25 turbo, must be in good condition. Thanks

Looking for ideas and feedback on an idea i've had. Rather than add fittings & remove the sump for an oil return i've been putting some thought toward a stand alone oil system to feed a turbo. Electric oil pump and small reservoir to feed the turbo with a return to an oil cooler and back to...

FOR SALE: CG bike carb setup. This is a plug and play kit containing CBR900rr carbs (currently jetted to suit a modified CG13 but will come with smaller jets to tune to your spec) they were sonically cleaned and rebuilt, offset Bogg Brothers manifold so the brake servo is retained, step down...

Evening folks, it's a long shot but does anyone have any information on the total inlet track length the NME for Nismo K11's run at all? Looking at trumpets to install next and any previous measuent would be a big help :)

Hi folks would anyone have a good stockist or a pair of good 2nd hand bleed nipples for the AV22 brake calipers. Iv bought 2 new sets now and both are too short to seal and leak fluid everywhere despite being listed for the GTiR by the manufature

Evening folks, can anyone confirm the cc of the red nissan top feed injectors? Been looking online and have 3 different rates, I seem to remember them being 199cc?

Hey folks, just looking to double check relay positions for a facelift as I can only really find preface info. The wiring on mine as normal doesn't tally well to the Haynes manual! I'm thinking the top left relay on the fuse board is the fuel pump and the middle blue relay in the engine bay is...

Can anyone give me an accurate weight for the 100nx front caliper setup please? Calipers / pads/ carriers / discs all togeather

Hello peeps of the MSC. Is there anyone out there far more tech/art savvy than me who could do a side on Photoshop of a decal for me?

Pair of 1.3 camshafts that were kept for spares no longer needed. Taken from a 38k miles engine £50 posted to the UK

K11 mud flaps, genuine nissan not eBay copies. Open to an offer The car doesn't get much use in the wet so they aren't really needed

Coming across odds and sods I no longer need, if anyone wants them they are free to a good home :) (all that's needed is the postage covered) If anyone else is in the same situation post away on this thread :)

Hello, Can anyone recommend the correct battery cable for a k11 re Amp rating? Also if the length of the cable has much of an impact? Any help always appreciated :)

Hello, I have removed the ally dash out of my k11 now. If anyone is interested drop me a pm. Will pop a pick up from my blog. Can be used with the heather installed to demist the windscreen