This is the route I took CGA3de bored to 72.5mm with vaux corsa 1.4 net pistons. CGA3 rods and crank. Pistons need machining so conrod goes in between for gudgin pin. also made them fully floating
The block was decked about 1 mm. I have 73 mm head gasket 1.2 mm thick from Matt Humphies.
Can any body Help please I am looking for some one to give me How much lift on the inlet an exhaust camshaft when crankshaft is at top dead centre on the CGA3de engine. Thanks
High fellow members, HELP Needed. This is for a CGA3DE engine 2002
Lets assume my camshafts have no dowl holes for the chain sprockets. I want to set up the valve timing using a crankshaft protractor and a dial gauge. I can not find any info online so have come here. I am sure someone...
Injectors
Fuel pressure regulator
Air temp sensor
water temp sensor
Air flow meter
Is it over fueling or is it not burning all the fuel? What is the compression like? what does it run like? Does it have an air leak as this can cause over fueling.
This is all guess work when you do not have a...
Has any one measured the block hight of a CG10 and a CGA3?.
The bores on my CGA3 are excessively worn and wondered if the CG10 block is rebored to the 1.4 pistons I could install my crankshaft conrods and pistons to make it a 1.4 engine. What do the think
Hi! I have a CGA3de engine and I have been looking for a valve cover to fit my engine. I need one that the breather outlets on the end are 90 deg and not straight'
I am sure there one out there somewhere and hope some will be able to help. Thanks for reading Paul
It been a long time since I worked on one, I do not believe you will need parts just remove gearbox then remove the clutch arm and spindle from the bell housing. I believe it uses plastic bushes. What happens is the alloy corrodes and exspands and the shaft rust within the bush. Just strip down...
I reckon the clutch arm that goes through the gearbox will be seized in the bushes, Gear box out job I reckon.
If the cable is disconnected from gearbox end the arm still stiff or wont move defo seized.
WAnted Micra K11 . I am in the North East of Scotland and am looking for A K11 cheap to dismantal. MOT fail would be good but as long as its cheap' Thanks
Thank you for your answers. I actully want A CG13 engine but can not find one and curiosity got me thinking.
This site does not seem to have an adds section, Would you know of a source for an engine