Nice thread hijack Big Jas I didn't realise you had a for sale thread on here. Unfortunately brad I had a recent clear out in the garage and got rid of most of the pao parts that I had left, but thank you for bringing this old thread back to my attention. I will edit it to show just the grille left.
Hey pollyp that is exactly what I was quoted by humphris, it's just a shame that I have only one broken ring on one piston (1 out of 20) if it's what I have to get then fair enough.
Hi there guys,
I am trying to get hold of a set of rings for one piston on an engine rebuild I'm currently half way through, I just wondered if there is any other outlet that you may know of other than humphris who only sell a set for 4 pistons?
Thanks.
James.
I managed to fit Vauxhall Corsa coilovers to my pao without too much work, that being said I have a k11 front end disc brakes, engine, gearbox etc.
Not sure how they would go on a full k10 pao.
Hi there R Works, as far as I am aware Nissan or eBay/Japanese auction sites are the only places left to go. The only aftermarket parts I know of are all mechanical as they are shared with the K10 Micra.
Haven't posted on here in a while, but the engine in my converted pao has given up the ghost
So I'm after a relatively low mileage engine (cg13 1.3 16v) from a k11 Nissan Micra to replace it with. I would also like to try and tune it up a little bit maybe.
It is indeed the one and the same. To be fair that was one of my first original thoughts after I had tested all the other things, I'm guessing that ECU is knackard then it looked like Ed had modded it so I may well have to get him in again.
Hey there @frank and @wehey I have tried disconnecting the fuel pump and also putting a small amount of fuel in the throttle body but nothing, it just continues to turn over. as for the ecu i'm not sure if its pre nats or not.
I'll attach a pic.
It was swap was done by fusion who i believe...
Hi there folks,
I have a Nissan pao but I have put a k11 engine in her. It was all running smoothly until I took her of the road to some welding, I finished to work dropped her back down and she refuses to start. I have a spark and fuel is all good I have checked everything I can think of with...