Recent content by J.Low75

  1. J

    K12 BCM removal

    Not sure about the water - it's not actually leaking in, so not the seals etc - it seems to collect somewhere inside the lid & drips down on the right hand side of the boot lid when you open the boot - well that's what mine does anyway. you will probably have a fault code on the ECU aswel that...
  2. J

    K12 BCM removal

    Remove the spare wheel + tool holder & it's easy so see/access - it's on the right-hand side of the wheel well at the back. It's only a short tail - the connector is right next to the alarm module. I dried mine out by disconnecting it & putting a fan heater on it for a while. I've actually left...
  3. J

    K12 BCM removal

    I had a similar problem on my K12 CC - I too thought it was BCM related, turns out it was water ingress on the Alarm connector in RH side of the spare wheel well! - check it's dry. I have discovered after it has been raining, when I lift the boot lid up a load of water runs off of the right hand...
  4. J

    Immobiliser/Alarm Issue - BCM?

    Hi all at MSC, I have an issue with my 2008 K12 CC Acenta - the NATS system would not recognise the Key & the red immobiliser light was flashing, I hooked up NDSII and cleared fault codes P1610 & P1611 this worked & I was on my way again. It then started happening more frequently & clearing...
  5. J

    New Owner/Member

    Hello to all at MSC, I have recently purchased a 2008 K12 1.6 Micra CC Acenta 84'000 miles to use in conjunction with two other vehicles I own, mainly to do a 4 mile commute to work, I also own a Nissan Elgrand 3.5 4wd camper conversion - which is obviously not really suitable for a daily 4...
Back
Top