Recent content by CMF_LWC

  1. C

    Wanted: K11 LX 95 rear end complete

    Thanks for the tips, I may be lucky and it's only a stub axle which makes postage a good alternative. Just need to pull a few bits off over Christmas.
  2. C

    Wanted: K11 LX 95 rear end complete

    Thanks, I may try for either.
  3. C

    Wanted: K11 LX 95 rear end complete

    LWC got a bent rear axle today :( checking out repair option/wreck. anyone in Canberra/Qbn like to part with a stock drum brake rear axle complete? Dom
  4. C

    WTB: clutch cable urgent

    LWC needs a clutch cable as she sits on the side of the road with no forward progress. Call me on 0414 479 398 if you know where I can get one Thanks Dom
  5. C

    15" Wheels that fit?

    Here's a chart of tyre sizes showing illegal sizes in red.
  6. C

    1995 NRMA K11 Bulletin

    http://www.industryresearch.com.au/bulletins/TechnicalPublicationsArchive/Nissan%20Micra%20K11.pdf This bulletin shows camber caster settings, body measurements, panels, etc.
  7. C

    -- Micra Part Numbers Thread --

    Engine Mounts: LH Kelpro MT8861 RH Kelpro MT9611 or RH Boonma EM4828
  8. C

    oils & liquids!

    3.1 litres with filter. Use a good synthetic oil like Fuchs 10w - 30/40w.
  9. C

    Re-soldering throttle body

    LWC had her throttle body resoldered last weekend. She was a joy to drive this week. Better fuel economy by 50kms per tank, the flat spot is almost not there (curse the cool canberra weather), and she has more power. Alex many thanks for the repair guide and pix. LWC
  10. C

    Hatch Gas Struts

    Just replaced LWCs hatch struts for the second time in 12 years! AutoBarn had stock Monroe units off the shelf for $48 each. The old ones come off by levering up the metal clip with a screw driver enough to slip them off. Just prop up the hatch with a helper!! The new ones just pop on with a...
  11. C

    Timing belt rattle

    The Izuzu 2L motor I had snapped a chain, bent some valves so I changed the timing chain & tensioner on (had the rachet action too). I think as everything wears, it keeps the tension on the chain when it indexes onto the next rachet tooth without the chain being able to flap and push the...
  12. C

    LH/RH ball joint replacement

    when you assemble the joint the upper seal tightens quite nicely. The pressure on the lower seal is okay. The TE4 may be a tighter fit on the upper side but I don't think it matters that much as it is shielded by the upper arm anyway. LWC
  13. C

    LH/RH ball joint replacement

    installed!
  14. C

    LH/RH ball joint replacement

    The photo shows the rubber boots. They aren't an exact fit but close enough to keep grot out! LWC
  15. C

    Advice on 4:1 exhaust manifold

    You could try this guy's site: http://www.my-acoustic.com/Car/intake_exhaust/exhaust/exhaust2.htm
See more
Back
Top