Recent content by CMF_klingon

hey all i need some original springs for the mouse so it can pass rego over the pits apparantly it sits to low not really the whiteline braces and swaybars sit to low so it wont pass if anyone has any in canberra that i can borrow for one day that would be marvellouss.

yep you picked it silver is the worst colur , you may get away with doing just one side of the hatch because there is a window separating both sides.

hey toma on the metal you need to ideally paint the whole panel unless your a genius painter who can blend like god himself. you need to sand the area first, make sure there are no edges called feathering out. then scotchbrite the whole panel wet with scuff paste. clean chamois dry, prepsol...

you definatly gotta use plastic primer man lay a light coat of that on then fire awat with 2 to 3 coats of base coat let dry not complety then 2 coats of clear. then shes sweet make sure you prepsol the bastards before you paint em other wise youll have lots of nice little bits of dirt in there...

we tried them on the original rails but me and my dad are a good 6 foot 5 or so so they are way to high. so do your seats slide forward 55.? you used all the original mounting points. its a shame the the rear of the seats are dummied up it would make stuff a whole lot easier if they were the...

we just need to pull the sliders apart but we cant figure that out. just wanna know if any one has done this

hi all we are trying to fit some new saas seats into the mouse. one problem i dont know if anyone hasd done it but because of the different heights of the mounting points. we need to pull the rails apart. any one know how this is done. anyone in canberra particuarly.

sweet as man ive just been at work crissie party since 1 o clock free jb's all day woo. we'll sort it out one day next year. catch yallll on thee flii[p side. merrry xmas..

yeah man but we also wanna re install the air con. cause my dad cant have a car without it. i can thats what windows and a singlet are for but try telin that to my old man. how muck was your front mount setup.

i dunno if this has been posted befor but you gotta check this out its dodge as but funny as hell. http://www.spagweb.com/magicspanner/v8_micra/

yeah but the water injections way to conservative for us it comes on as soon as you hit boost we need a day on the dyno and fine tune the water injection. the sectioned off inter cooler compartment should look pretty off tap hey. we'll post photos as we do it.

as some of you may no, MOUSE! the micra formerly known as mighty has a side mount inter cooler set up it is very good but it needs cold air desperatly. we are going to fit a vent in the bonnet. and seal the area in the bonnet off with plate aluminium heat sheilds and window rubber for a true...

he he tassie what a place. its just like the south side in canberra. JJ :). from now on mighty is now called 'the mouse'. i like that mighty mouse idea it freakin cool.

would n14 reatr discs or gtir rear discs bolt up just tell me is there an easy way to put rear discs on a lx.

yo cisco that white super s was ours before we sold it to that guy thats why we like the bbs's so this is our 2nd micra.