Recent content by CMF_CENTI

Will tires with size 185/70 R14 fit the micra all others being stock?...

Just came across videos in youtube where using a handspray and spraying water into the intake should decarbonize the compression chamber, top of the pistons and faces of the valves? how true is this? if we do this to our micra, isn't there any risk of frying electronics inside the throttle body?

I want a ever so slightly different exhaust tone on my CG10, on the process of taking out the muffler while the engine is running, while unscrewing the 2 nuts connecting the muffler to the pipe, the tone changed. I thought the change in tone is what I want...I inserted 2 small washers to the...

just posting my observation. thanks to Mike R, yep youre right about the diameter, used an 8mm copper tube about 8 inches long to connect the hoses together... read somewhere here, some reported no effects felt after this modification... I don't know if its just me, but I definitely can notice...

what is the correct size of the metal connector/ pipe /hose coupler to be used??? 8mm copper tube???

i was running 70-80 kph, I was carrying though 7 20liter water bottles at the back, with the hatch unlocked...poof! the windshield which was a tempered glass fell on me and all over the place...haven't seen anything that hit me from the front end or the sides :-(...a stone maybe from oncoming...

Is it possible a smashed windshield is caused by running with an unlocked hatch??

thanks mate.

have tested my car's TPS(mid wire and front one)with a multitester last night, it returned less than .5V at closed throttle, .40V specifically... have read somewhere it should be .5V...how is it affecting my car? fuel economy? throttle response? have been driving the car with that condition for...

mine turns on after a certain low level, after approximately 5-6 kilometers turns off, after another few more kilometers turns on again the second time. what must wrong with mine moisture sensitive resistor?

ok thanks... vacuum leak from where? where do I start checking?

cranked my car in the morning, let it idled for about a minute then drove off, within the next kilometer or two, the engine cuts off every time I step on the clutch to change gear...what explains this? but if i just leave the car on idle, it just continuosly purrs and not cut off and the idle is...

micra porn!

the guide says only 6 points to resolder? please confirm... or do we have to resolder every point where solder is applied?

my friend's micra is a CG13, mine is a 1.0, how come ours is almost the same consumption around 13-15kms/liter city drive... or maybe i messed up the way i measured...any suggestions? is there really big difference between the two models in terms of gas mileage/consumption?