Recent content by chud

if anyone is interested I swapped the caliper with one from a scrapper and it seems ok now. just writing this for info if anyone searches the board for same issue... only needed about 1/3 of a 500ml bottle of DOT4 to bleed it through. (i bout 1l and this may save someone buying too much!) -...

scott, thanks for your reply - do you know if all the ones on a K11 are the same, does engine size or year matter etc? some of the fleebay descriptions are a bit vague and the pics not great the p/n looks like 6732170612 (2's may be 7's and vice versa, somewhat corroded!)

..bit more info.... Last MOT it failed for OSF binding - removed caliper, exercised piston in and out about 5 times and exercised the sliders (seemed free). I also did this on NS and it didn't seem any better or worse than than OSF. The year before's MOT , same story, OSF binding, although this...

Hi, Drove about 5 miles home with very minimal braking and got out of car, could smell something hot - front drivers side (OSF) was very hot. Jacked up car and wheel barely movable, started to take caliper off. In the course of removing bolts gave it a few good knocks with rubber mallet and...

mine froze in the ice of late, but after the thaw they still weren't working...this is how i fixed them. 1) unplug the hoses from the barbs (good yank), check water then comes from hose ends so u know everything else is working. 2) unclip from bonnet and take the two ends inside as its bloody...

yes it fitted, just :) FYI - if anyone uses their little micra's for large loads, I would suggest removing the rear seat (top half), there are 4 easy to access bolts that hold it on only - takes a couple of mins to remove. If you want to stick in long loads you can also remove the front...

ok, thanks guys, ill give it a go :)

Hi, Does anyone know if a normal full size dishwasher (not in a box) will fit in a K11 boot?? (I already have the rear seat top half off as I was transporting some joists, so it would lay flat) I roughly measured the boot opening with a tape measure and it seems like it would fit but I...