how did you go about lining it all up and drilling the holes into the pulley? will look at your build thread over on 16v as i think i might have missed something, also looking at your frame from this side i notice you have managed to get away with just putting a bar from tower to front!
i am not after taking the engine to pieces i dont mind changing cams, air filter doesnt need changing nor does the throttle body as i have sorted those,
looking at fitting a 36-1 Trigger wheel onto the bottom pulley how do you mount it? and has anyone done it before?
how have you mounted your sensors? and are there any worth while upgrades whilst the engine is out the car waiting to find a decent shell?
so far i have given it a service with...
nice one mate, that is a good bit of information! looks like i am going to have to buy a couple of things and do some research but thank you and thanks again!
shell will be going to scrap as soon as i recieve the log book for it which will be in the next few days :( i have taken a few bits that i want from it
was just planning on using the tps that is on the side of the bank of bike carbs if its possible and just change the connector from the standard micra ecu
i was thinking earlier on today,
would it be possible to retain the fuel injectors fit bike carbs and just use them as bodies to control the throttle and not run petrol through them at all?