Recent content by bikepmist

Anyone?,or know of someone that has one?.............

Hi everyone!,has anyone a good ma12 cylinder head for sale?,being quoted crazy prices from breakers, thanks B p,

Thanks once again Frank for your time and help!,i hope the bed wetting problem dries up,i do not want to have a mental picture of you in my head wearing "a nappy"!!,lol...... B p

Hi Frank your up early!,busy man i suppose?,how did it run with 3 mm skim?,i am just worried with the higher compression pistons, that is less of a "dish" on the tops, that i might have piston to valve issues?,thanks for the reply by the way!,you are a good man and always willing and helpful to...

Hi there,have the high com k10 engine,putting ma12 head on ,need to know max skim in mm i can take off i am no good at formulas for cr,so if anyone knows in mm to skim it would be great!,thanks guys!

Thanks Frank!, you are the man!.

Thanks skymeara,this cam is ground for top-end power so low down power will be lost a little to benefit the top-end range,so my understanding is more valve lift and longer duration equals more power,more power equals more revs?,maybe FRANK the MAN COULD SHED MORE LIGHT ON THIS!,what do you say...

Hi everyone, i have got a reground cam for my k10 ma1.0 micra,i will give specs later,i would just like to know if i now need to fit a rev limiter to the car as it will be reving a lot higher up at the top end,that is high up in the...

Hi Frank' thanks very much for the reply and info!,you say dual springs,what second spring would you use!,what car would it come off of,i am assuming that would be used with the origional valve spring's,would both inlet and exhaust springs need the second spring?,and what cam...

Hi all, looking at how to get my k10 1.0 to rev a bit more for oval racing,i have a 1.2 cylinder head on it that i got skimmed,a lightened flywheel,carb re-jet,advanced ignition,it also has new piston rings and rebuilt bottom end,i just need to get a few more mph out...

Thanks very much for that Josh!.

Hi people!, would 14' wheels fit my k10,if so what car would they have to come off of,and would i gain any speed in the lower gears,not worried about top gear speed! thanks.

Thank's Frank, and all of you that responded!, I know motorbikes use the same engine oil in the gearbox and they have no issues as well as ATV'S etc, thanks again guy's!!!..

Hey Frank, is there any noticable difference, and why if you don't mind me asking, do you still use use it?, thank's.

Hey Skymera, you must have been on a "tight budget" using used engine oil!:), did you notice any difference in performance "honestly" and would you advise using it or not using it????...