Search results

The outer cv boot on mine has split and no doubt the helpful guidance on here will be super helpful without a doubt. So thank you. However, someone in one of the posts somewhere on the site has suggested fitting an original Nissan part. I'm glad I was sitting down when I called them as Nissan...

Mate, I drew a diagram and labelled it with the dimensions after measuring the grilles on my shelf, but this forum wont allow me to post an attachment for some stupid reason. The FAQ section re. posting images/attachments is about as much help as a chocolate teapot. Sorry mate, I tried again...

Is this offer still valid?

2001 x 1.0l 60000miles, halfords semi-synth. Works ok for me

My 1.0L didn't come with a manual/log, so use THIS, obtained from the clubnissan site, though I do change the engine oil every 5k. Not ideal, but better than what I had.

I take it you've never had an old mini 850 then? :p

I don't know for sure whether a warning light circuit is fitted, but I would have thought it is. If so, then it's a yes to both your q's. It could be either of those. Switch under the h/brake is the more easily accessible so would be the first thing to check. If all's ok there, then suspect...

The fact that the car is in neutral makes me believe (I'm happy to stand corrected on this) that the ECU detects speed, and as such increases idle slightly when it realises the car is moving with a closed throttle. When the car becomes stationary, idle falls once again. Mine's the same mate. In...

Standard NGK plugs are BKR5E-11.

Where abouts are you and how much for rear parcel shelf (Im after the one without the cutout for the high level brake light, 2001 model). Thanks.

Thanks for the info. Would still ideally like a definitive answer as regards idle adjustment, if anyone knows. C'mon...someone must know!!! Cheers.

Jabran, adjusting idle by removing slack from the throttle cable is a big no-no in my book. Frank, couple of questions mate...... * What do you mean by "set via consult"? Is that where a device is plugged into the ECU to up the idle electronically? If so, what device? * What device do...

Had the car 2 weeks. Engine sometimes stalls when coasting to a halt. Changed plugs, oil and all filters, and cleaned the idle control valve. It made no difference. Replaced the MAF sensor, and theres a small improvement. However, its still idling a little low, even hunting. Thats why I want...

There is on the pre-2000 models (the ones on which you can re-solder the dry joints), but not on the Bosch throttle body. I've looked all over the thing for half an hour and the only adjustment screw I can see is the one at the back of the t/b that moves the quadrant (the thing the throttle...

Anyone know how you adjust the idle on a post 2000 1.0 micra? Searching here I couldn't find any info on how to adjust it on the ones fitted with the Bosch throttle body. Help appreciated.

Thanks all for your replies. I've done a lot of internet searching and cross-referencing for plugs, and all listed that either can be used (bosch and ngk). One even listed FR7DCX for the Micra. What I was getting at is that there are several posts on here (do a search for FR8DCX and you'll see...

Hi all, 1st post but been a lurker here for a little while and have now bought me a 1.0 X-reg (2001 is that?) Micra S. Anyway....... Have been searching and reading loads throughout the forum about which plugs I need for it. I'd already done a service on her, all filters etc, and fitted BKR5E...