Search results

Alright, can't have this........ There are a few bits that will technically fit but they don't all work. The K11 rack will go but is a couple of inches wider. This can be made up using either of the following methods: - K11 rack, K10 wishbones, K10 hubs & balljoints, K10 Track rod ends...

Yeah man, it was the K11 kit I ordered but had to do a little cutting & drilling to make them fit just right. It's only the front bush that needs modification and it only took a few minutes. The alternative would be to visit your local machinist who will do a far superior job & won't charge more...

Hi-ya whipit, I did think about using camber bolts but ruled it out because even if I could correct the camber, I would be left with a 2" reduction in track width. Seemed counter productive. In the end I finished up with K10 arms, had to cut the old balljoints out & polish away their...

Cheers Frank, I've taken a few rough measurements & settled on removing the old Ball-joints from my K10 arms. I hope to replace them with K11 ones. I have stitch welded the K10 arms & drilled them to accept a K11 anti-roll bar. I have cut out the K10 ball joints & am going to have a shot at...

Afternoon Frank, I'm not 100% sure about the K11 balljoints in the K10 arms. That was my plan until I looked at the part in the auto factors this morning. The K10 ones are shrink fitted from the top of the LCA & the K11 ones are press fitted & circlipped from the bottom of the LCA. I'll be...

Afternoon all, I'm having a bit of a headache with my wishbones. I've swapped in a complete set of K11 wishbones, hubs, brakes, roll bars etc. with Poly-bushes everywhere. Fits fine, steering is much improved & all that but the lower arms are a full inch shorter than the K10 version. Even by...