Recent content by ror100uk

Had this on the other half's K11 last winter. In his case it turned out to be the driver side lights fitting itself (the black wiring plug which goes on the back of the bulb), kept blowing bulbs all over the shop. £10 at a dealer and a bit of DIY had it sorted in 10 minutes. I then noticed...

Well i figured it may take a while for the engine to settle with the new o2 sensor, and the computer is still returning 54mpg (5 days of 6 mile commute each way to work) and 2 evenings of 35 miles each way to see the other half), so I'll see how it goes at the pumps this weekend when I fill up...

In the end I purchased a new aerial top from an Ebay seller for £3. Genuine Nissan part and its transformed the reception. Now all I need is a good set of trims (rather than the crunched ones I have) and I'll have a cracking little car!

All sorted - got my dealer to supply a new barrel which had been rolled to the original spec. £200 later and all is sorted, did the fitting myself. A good deal imo, and faultless service from WLMG Nissan in High Wycombe.

Cheers crack fox. I used the guide on here to look at the aerial connection today, and the aerial was all connected correctly. I had a look at the aerial on the roof and all looks well. I think this weekend I will see if I can get an aerial amplifier fitted in and see if that helps.

Well O2 sensor has now been replaced and I'm amazed at the difference! The car was smooth and peppy before, now its silky smooth and a very nice runner. Also my mpg has been transformed! Reset the computer when I left the garage, and I'm now getting 61.9 from the computer, so I'll expect...

Thanks Frank will let you know how I get on!

Hi all, Based on the positive experiences of my boyfriend in his K11 micra, I've just bought a K12 1.2SE. I've got a couple of small niggles that I'd appreciate some help with. 1. Engine management light came on within 18 hours of leaving the garage, the AA diagnosed it is running lean on...

We've tried everything under the sun, it won't budge. This latest attempt needed about 35 tries to get the key out. I've even suggested breaking the key off in the lock and starting it with a screwdriver, but you can imagine how that went down with the other half! If it's only the plastic...

Hi all, My other half has owned his K11 for 5ish years now, with very few problems. However, now its becoming VERY difficult to get the key out of the ignition, and I think it's time to get a new barrel. Is it possible to get an exact replica barrel direct from a dealer (stealer?), as I did...