Recent content by MrColourz

  1. MrColourz

    Micra k12 suspension

    I really hope someone can help I was wondering if you can put any other struts/coilovers/bags that are the same as the k12 like Silvia or 350/370z suspension on to a k12 as I've been searching and searching for a set up that will go lower than 50mm
  2. MrColourz

    Cr12de turbo

    I have looked into this before and can cost 2000 just for fitting everything.then you may have to fit better bottom end to handle the boost... So can easy hit 3-4K
  3. MrColourz

    Front end seems to be touching the floor?

    Can be anything might be the wheel arch liner or maybe your bumper has uncoiled from the bottom rail that goes across the front like mine has done before... Hope it helps
  4. MrColourz

    Looking for k12 lowering springs

    If you go onto the eibach website they have 3pr 4 sets of springs on there that lower curtain amounts I got the lowest ones which lower 50mm
  5. MrColourz

    Removing rear inside panel

    Neve never mind
  6. MrColourz

    Removing rear inside panel

    Where are the bolts because I just pulled mine off didn't know there was bolts holding it on :/
  7. MrColourz

    Front and rear light units

    im really struggling to find any aftermarket lights for my k12! Please help me!
  8. MrColourz

    How to remove rear door panels

    I just pulled mine as hard as possible and will in clip from the body easy to repair speaker held in by 3 Philips screws
  9. MrColourz

    k12 newbie, lower seat?

    From what mines like there's loads I'm 6ft and I fit :) and common problems not a lot I know of a common problem with o2/lambada sensors and also the boot rattle... Other small problems that aren't as common is the boot button plays up on mine and have seen on other micras... Also had a few in...
  10. MrColourz

    Do the K13 seats fit a K12

    I also would like to know!
  11. MrColourz

    New to MSC and gratful for help!

    Hi I really want to do this conversion on a k12 do you think it may be easier or harder to do in respect to engine bay size? And also really inspired by this build! Wish to see more like it!
Back
Top