Recent content by Mayze

So I finally got round to working on it again, after taking the torque converter out I found a couple of pieces of the old brushes which must have broken off and where jammed between the slip ring and transmission housing causing a short. Now after cleaning the slip rings, replacing the input...

I'm assuming If one of the sensors on the throttle body were faulty the ecu would throw a code yeah?

I ran a diagnostics test, dont have the scan tool so did it the manual way. It came up as code 55 which is no faults detected on the ecu.

Hi thanks for the reply, once I get the drive going it has the cvt light blinking but once I brake and it stalls the light is constant. I have drained the fluid and taken the sump off to check the magnet and there is no metal or contamination so I assume the belt is ok. I couldn't change the...

Just a little update. While checking the fuses and relays i found that if I removed the cvt relay and refitted it while running and in gear the cvt went into drive / reverse. As soon as i used the brakes to change gear or into neutral/ park it stalled. Would I be correct in assuming this would...

Just curious if poor condition powder within the cvt clutch can cause code 4 circuit issues?

Hi everyone, I have an 1995 1.3l k11 micra with the ncvt transmission, after cv seal replacement and oil change it has no drive. The selector is moving fine, I have removed the electro magnetic brush holder and they are excellent condition I have also checked continuity of the brush holder...