Recent content by lucyisaly

rodent 279 hi there is no code u1001 on my list of faults, could you have read it wrong andy seadog sorry if this is not good for you but maybe you would know what rodent 279s fault is

sorry dont understand If anyone needs to find out what a code represents i have the full list here it is probably a bit long to post so just mail me

Hi after a recent fault with my k12 i found this information on diagnostics quite helpfull and thought it may help someone else Accessing codes Ensure accelerator pedal is fully released Switch ignition on. do not start engine Wait 3 seconds Within 5 seconds repeat the following 5 times...

thanks for that frank i will get the cover off and check it out, if you would like the info off autodata for future reference let me know and ill send it to you

sorry ive looked on autodata and there is a sequence to carry out to get the fault codes, i will try it in the morning, would a faulty timing chain give these faults

the water level is spot on mate so dont think there will be any leaks, ive got a new throttle position sensor from nissan today i will fit it tomorrow and see if that works, after 4 years of trouble free motoring the wiper motor has packed in now aswell one of the plastic sockets on the linkage...

thank for the help i have tried it today and it wont idle even when its warm now so i guess its more likely to be the throttle motor postion sensor

no it runs fine when warm, there is a plug near the rocker cover when i unplug this it idles fine but the accelerator does not work

hi i have an 04 1 litre micra that is stalling at idle, i have had a few k11's with this problem and it was a throttle boddie problemwhich was sorted after re-soldering the connections, does the k12 have a common fault similar to this thanks liam

check this k11 out on ebay Item number: 260376833865 cool for a girl

thanks frank you have been very helpfull, ill get one and give it ago. sorry not sure what imo is i dont understand these abbreviations

im getting 0 on the primary and 1000 secondary i have removed the coil and briefly connected to battery and i do get a weak spark but when it is connected to the car i get nothing at the plugs, could i still get a weak spark with a faulty coil

thanks frank there is no spark do you know what readings i should get when testing the coil (the coil is in the dizzy) is this a common fault

hi i have read the fault code on my k11 it flashes up as 21 this is to do with the ignition i know but what could the fault be, thanks

if it is the nats what is normally the problem is it a fault with the reader