Had half hour on my break today so made the first cut on the micra and ordered some tube. Will cut the other side tomorrow if i get a chance. Also pulled the audi out of hiding, so will try find an evening or 2 to strip that down..
If any of you lot use anything like Snapchat or WhatsApp etc and wanna see what goes on with the micra ill quite happily share the progress as well as on here :)
Ive always loved fourtraks. Theyre absolutely brilliant. But back to the micra.. ? Im gunna go make a start on pulling the front legs off the micra this weekend!
Yea luckily ive got a couple of vag gurus close to home so ill call upon them for a few favours.. If what your saying about wiring, imob off etc then id be better off getting it wiped before i pull it out the a3 then. Yea spare wheel well will be cut out along with the rest of the boot floor to...
If the emerald ecu doesnt make its way to me ill be aticking with the standard ecu etc
Im gunna try and keep the standard width tbh after measuring etc last night its gunna be a lot of pissing about as ive got to gain 3 1/4 inch each side of the original turret. Gunna measure the width of the...
Will be using haldex mate. Got a whole running a3 that I'll be ripping to bits. Mate of mine might have a spare emerald ecu already mapped that may find its way to me so thatd save a lot of time.. But im just looking at what steering rack to use? I dont think the micra one would hold up for too...
Plan was to use the XUD but the cambelt snapped on my mates van so that will probably get put in that. Reason for spacing the front was to fit my 1.8t quattro gear in it. But after a couple hours with the tape measure last night i wont be moving suspension. Im gunna make a roll over jig to put...
Im really not fussed at how long it takes as its in my dry workshop and will be till i finish it. Wiring is not an issue as i have everything still sat in the car running etc and can shorten/extend where needed etc. As for the negativity on moving the top mounts etc, ive seen far worse on the...
Who wants a smaller engine ;) there's got to be someone whos gone all out on a k11 and done something different? I was mainly wondering how im gunna move the top mounts/ strut towers?
Calling all micra nuts.. Ive just pulled the k11 apart to drop the xud lump in it but now considering changing plans. Im just wondering if anyone has space framed a k11? Or even just the front end? For my new plan to work ive got to make the front and rear track 6 inches wider! Not something im...