Recent content by dave ravensdale

Hi guy I have changed all the seals on the manifold was seriously thinking injector though is it an easy job?

Ok got update code p0304 again any suggestions frank? Injector perhaps?

Ive not been able to get code reader till I see my brother when I collected seals from nissan they said maybe post cat lambda but id have expected a code? or is that too sensible? Just cant understand why it goes at higher speed and not below a certain speed

Ok so update time replaced all air seals missis been driving locally from then and no problems took car today on a bit of a run on motorway and car stumbled again at around 70mph with mil light flashing but not solid. Drove back on motorway approx 30 miles and no light at 60mph im confused :-/

By replacing these hoover did it sort ypur problem? What were symptoms. Picked a new set up from nissan today along with the small on that goes into rocker cover full set £17.20 which I didnt think was bad if it works

Thank you hoover im not 100% but one has definitely seen better days and the little seal that goes in the rocker cover is a mess too. Picking up from nissan tomorrow and about £17 for all. Will post part numbers when I pick them up. Just need the car then to fit hoping sunday. Going to pick up...

It was just a thought just purely because of the symptoms. I think its worth £20 for a new stat and bit of coolant likewise the air intake seals will be cheap enough and definately worth changing

Just one more thing the symptoms experienced are similar to the thread re poor running problems and thermostat do you think it could make a difference?

Thanks for your help so far if not I'll be in touch it looks like al have to order from steeler but will report back

Does anyone know where to get these seals from? Are they nissan only part?

That might be worth a shot they were a little battered and bruised and also the little seal on top of rocker cover leading to air box was too. Are they dealer only any ideas?

You can hear her missing when light acceleration whilst stood still and shes running a little high on revs at tick over too about 900 rpm

Thanks for prompt response frank it does look in spec From what I can see no more than 6 mm

Is there anyway to check that?