Recent content by CMF_gocart

  1. C

    ROH 14' Alloys - wheel nut seat angle

    Thanks very much Chris - very helpful. I'll track down some steel 60 degree tapers - I can eliminate sphere and flat seating from looking at the seat. Cheers
  2. C

    ROH 14' Alloys - wheel nut seat angle

    Hi Guys, Finally tracked down a set of 14" alloys (ROH Reflex 14"). PCD = 4 x 100mm. Anyone help me out with some info please?: 1) Is the wheel nut (M12 x 1.25mm) seat angle 60 degrees? Any suggestions of where to get a good set? 2) Anyone know the offset? 3) Would you go for 165x60x14 or...
  3. C

    First steps

    Hi guys, Found a set of alloys - anyone know if they would fit a 1995 Micra, please? I think that they are off of a 1996-1998 (KJ/KL?)Laser. Info over phone: Numbers on rim: ROH 6JJx14; N165; 220B; WIA 96; 31 Would the 31 mean 31mm offset? Any ideas welcome? Cheers
  4. C

    First steps

    Thanks guys, appreciate the help. This is just a $3000 cheapy run around - but after newer bigger cars it feels like driving again - love it! Compared to my last drive to work car its cramped, less powerful, colder in winter etc etc BUT ... I can feel the road through the wheel, hear and feel...
  5. C

    First steps

    Hi guys, On my second stock 1995 K11 (4 door, blue, manual, air and steer fitted by original owner). My daily drive to work that I would like to customise. Really enjoying weaving through the morning traffic! Can anyone offer advice please on: 1) What are the critical specs to look for when...
See more
Back
Top