Recent content by CMF_giannishazel

you can also fit the 257mm ones in 14inches..well they leave little clearance but they do fit in my alloys.of course it has also to do with the wheel offset and design but if you use 247mm you will be fine with any 14 alloy wheel

frank you are right again about the ma.i have drilled the second hole to the first upper shell that overflows to the crankshaft gear in order to lube the lower chain already.i will just leave the other shells with a single hole and i will not drill another new small one in each of them.although...

well frank i just took apart the crank and drilled a hole to the first upper shell little bit smaller than the original one that alredy has.it is allinged now with the second oil passage of the block.i will leave the other upper shells with just the existing hole and i will not drill the smaller...

thanks so much frank..although i thought the oem ones had a single hole.all of them

well it does have a second hole but frank have you ever seen from your expecience an oem cg main bearing with 2 holes?i mean maybe it is supposed to be "blind"so as the oil to overflow outside the bearing...confusing...and the thing is that i have thrown away the oem bearings and i can not...

yes the conrod bearings fitted ok frank,no mods required there..now i see what my mistake was..at the first crankshaft bearing upper side the aluminium of the block has 2 oil passages and all the other passages where the bearings sit have one.all the main bearings of the ma have only one...

certainly not.you have to get the whole package both discs and calipers

thanks frank

frank can you tell me something about the 2 oil passages in the second pic of pollyp?the engine i am rebuilding has a single passage in the block so did the bearing i put(ma) although the 2 holes(block and of upper bearing do not line up perfectly but at least you can stick 2 toothpics...

well i will go for it.mine is a bosch 044.thanks dens.

the funny thing is that my block has 1 oil passage in the aluminium and there i see 2!!mine is a cg13 1992..

thanks wudi.have you done other mods?like puting a bigger amps fuse? cause i think that since it is a bigger pump maybe it will need more amps to work properly.

I did the same notch frank. it does fit fine.thanks again.i will keep you informed about the conrod ones

well i do have a 255 spare bosch fuel pump and i am planning to put it on my micra.i will use ga15 injectors,k11 fuel rail and regulator on a tunned cg13 engine.my micra pump already has 200.000klms and since i already had this sitting on my garage i am planning to put it in.has anybody install...

frank i have seen that already.the box outside clearly says for MA at pollyp s engine but i could not find details about the grinding that i have done.i am sure that they do not fit without the grinding.it does not stays in place.i am reffering to the main bearings since i have not open the...