Recent content by CMF_frank2

  1. C

    A little advice needed..

    the lambda readings when the fault occurs will give a good indication of whats at fault jack, just a volt meter tapped into the middle wire :)
  2. C

    Setting the distributor cap / ignition timing

    fine ta :) had to sell up and buy a van tho, so just a casual observer now
  3. C

    Setting the distributor cap / ignition timing

    correct ^ the k11 uses timing as a form of idle control under certain conditions, so you have to lock the ignition in "base timing mode" first i used to run the strobe and ecu talk software both together instead, and then twist the dizzy till both the strobe and software dial were reading the...
  4. C

    mini micra turbo

    lookin good miniman :) similar to the sr20 sidewinder mani eh
  5. C

    no cold start intermittent missfire

    valve timing out 1 tooth maybe ? post a pic of the lobes @ tdc like in the valve timing threads on here
  6. C

    Rear light won't turn off.

    brakelight switch maybe ?
  7. C

    no cold start intermittent missfire

    so thats ruled out a number of causes, does it start better from cold if you wet the air filter with a drop of fuel ?
  8. C

    no cold start intermittent missfire

    the readings will depend on what refresh rate the voltmeter has, so yours is closed looping ok from what i can see does it hold at .9v at wot, and 0v on lift in 2nd gear tho ?
  9. C

    no cold start intermittent missfire

    it seems to be closed looping ok, but the k11,s have a speed sensor that holds it in closed loop in 3rd/4th/5th, it should do the same as this vid if the sensor wire is disconnected (or if you try in 1st and 2nd gear) ie, it should bounce around .3 to .7v (closed looping) at cruise, then raise...
  10. C

    no cold start intermittent missfire

    yes very :) the middle wire on the lambda creates a voltage when hot, so a voltmeter from there to an earth somewhere
  11. C

    Intro. Hi all, new K11 project.

    sounds good paris :) there are a couple of SR builds on the dutch forum iirc, + stani,s build on the almera forum, and dave bull,s little bandit too eh
  12. C

    bigger flywheel(Frank)

    GA16 rudy, baguete used an alloy fidanza one that i posted up some measurements etc. the centre bore is slightly bigger btw https://micra.org.uk/cmf/message/67714
  13. C

    ghetto turbo build page 3

    pic wont load for some reason :( had to link them here https://www.micra.org.uk/threads/what-did-you-do-to-your-micra-today.43944/page-436#post-709501
  14. C

    ghetto turbo build page 3

    we,ve done another burble mani this week :) swapped the primaries over this time, from left to right and welded an audi tdi T15 to it
  15. C

    GA15 throttle body

    looks like a QG one to me, here,s the edm GA16/SR/CG ones
See more
Back
Top