Recent content by asdame2

thx robert yea i know, the thread was originally for findin help bout the crossmember rust repair and turned into a blog for the entire restoration project over time. dunno what to title it as.

i have a couple of problems tday i'm finding that the polyurethane bushes on the whiteline rear sway bar always tend to seize up, even after using several types of grease, and probably causing this occasional knock noise when cornering. was changing the bars setting tday and with the drop...

good luck with it sonic oh a note about the seats i fitted, i retapped all the threads and some bolts were replaced cos they were stripped or stuck. heres a estimate of my adventure will clock up at least a thousand miles, whole days worth of total driving, 111L of fuel = £115 should...

these are my modded runners

i've fitted these seats onto mine compaired to the stock seat, they're a nice cheap upgrade needs custom subframe welded to fit check out my post #108 for details http://micra.org.uk/showthread.php?p=257645#post257645

aye. gives better cooler air than either the warm engine bay (tried running without inlet pipe once) or the restrictive original pipe. was dawsons car lowered or the inlet pipe sticking out too low below the bumper? cos my ride heights stock and my inlet pipe is level with the front bumpers...

during the freezing periods in feb, the car did refuse to startup one night, dunno why. i checked air, fuel, ignition. all fine filter was good. all 4 sparks worked. disable fuel pump n cranked out the vapours incase it was flooded. reassembled, it struggled to start. after trying hard i...

hey japseye the buckle is trapped inbetween the bracket that comes off the seat base, and the seat back. but aye that seat base bracket is not the sturdiest point to withstand mega stresses. MOT garage guy says as long as the buckles attached to a solid point of seat/car incase ur upside down...

hey everyone. has been awhile since me last post. massive update coming......... * SPOILER I dremeled off the bolt brackets and side brackets, scrape off the original sticky foam strip on the edges and decided to bond it to the boot. found my local partco shop sells their own branded PU...

hey guys long time i haven't updated here. i eventually fixed the smoke & oil consumption prob by replacing the PCV valve and all was good. got the valve off nissan for £22