Recent content by appleman

As far as I was able to research, it is some Taiwan company. You mean, this Jecz would actually be the typical original part that Nissan themselves had used for Micra K11 manufacturing? By the way (getawaycar) - are there any particular steps in regards to possible faulty installation of the...

Hi, the throttle body I got is made by "JECZ" company. Is it suspicious/bad, unknown, fine? Thank you. Thank you very much for the ideas! I will try to share these with a mechanic (a different one that the one who did the original fitting, seems I found somebody reliable - but only after TB...

Hi, Few weeks ago I got throttle body replaced in Nissan Micra K11 (1997) due to MAF diagnostics error and the engine jerking while accelerating and cutting off when idle. (The throttle body used as replacement was new, though not the Nissan UKP 700 catalogue item.) However all these...

OK frank thanks, so basically if the ebay seller promotes this as NEW NISSAN MICRA AIR FLOW MASS METER SENSOR Car: Nissan Micra Bosh Part Number: 0280 218 040 NISSAN - MICRA (K11) 1.0 i 16V 08/92 to 09/00 they are mystifying (to say the least) as for the given years...

Tezz, just out of curiosity, as I have similar problems with my K11 / 1997, how do you unplug the MAF sensor, and do you know if the car can run without it being connected, or is it dangerous? (I'm no engine expert, all I can say is where the throttle body resides under the hood.) Thanks!

Hi, I have some issues with MAF / throttle body and so ordered a new MAF via eBay to have it replaced in a service. However they told me that: 1) They cannot get inside the throttle body because it is sealed (not sure why they could not simply unseal it? They said that later models have some...