Recent content by andre_f_carvalho

Yes, you need to take the dach out Enviado do meu GM1910 através do Tapatalk

Ma10 it's 10.5, but its the same block Sent from my GM1910 using Tapatalk

Upload with tapatalk Enviado do meu ONE E1003 através do Tapatalk

This is N14 240mm but it's the same Enviado do meu ONE E1003 através do Tapatalk

I made a spacer for them, remove a little of the disk and put that, later o will send a photo Enviado do meu ONE E1003 através do Tapatalk

Only need to center a capilar on the disc, you will se if you mount directly Enviado do meu ONE E1003 através do Tapatalk

You don't run a wide band? Enviado do meu ONE E1003 através do Tapatalk

Have you check the timing? Or other minor things? Enviado do meu ONE E1003 através do Tapatalk

Can be, not really adjusted, and with the engine warm exist more proper seal Enviado do meu ONE E1003 através do Tapatalk

With router cnc it's alote better Enviado do meu ONE E1003 através do Tapatalk

Have you put new rings? Enviado do meu ONE E1003 através do Tapatalk

Put o bit off oil and test the compression again Enviado do meu ONE E1003 através do Tapatalk

Have you changed the valve seals? Enviado do meu ONE E1003 através do Tapatalk

You can also cut my middle between the pair of valves to create a smoother path Enviado do meu ONE E1003 através do Tapatalk

Yes a little but, it's a good work lol see this https://www.youtube.com/channel/UCxOA2WgPT8UBm39xfir2zyQ Enviado do meu ONE E1003 através do Tapatalk