1400cc engine

[northernmicra]

hiya just wondering if its possible to put the 1400 crank and rods and pistons into a 1000cc as my bores are very worn and i have a spare 1.0 block ?

 

[frank]

the CGA3 crank and rods with 1.0 pistons gives 1311cc (2 head gaskets needed), and 1 member has just had his 1.0 block bored to 72.5mm, so i guess the CGA3 pistons will be fine

 

[northernmicra]

so i will not be able to just whack in the 1.4 rods and pistons ? what sort of compression ratio with i get with running the x2 head gaskets ?

 

[frank]

here was my 1311 project
http://www.micra.com.au/community/message.php?messageid=65695

 

[northernmicra]

ok will look later and can u answer these for me-
what cams are best to use ? 1.3 or 1.4
what is the best head to use dizzy or coilpack
and what bhp u get out of it ? running a standard inlet though ?
and what compression u get ?
and was it reliable?

 

[northernmicra]

any idea anyone ?

 

[frank]

the cams are the same profile, and to run the coilpack head you would need coilpack loom/ecu/throttlebody/coils/all sensors etc

 

[r-reg-sr]

this is mad