• Please only use these forums for blogs, they are not a discussion forum

Will3's Micra K10 CGxxx

OP
OP
Will3
Aaaaaand i'm back! project had to be put on hold for quiet some time, on the left is a 1.2 from -89 (rusty piece of ****) which will be donating interior, bumpers etc to do facelift on the 1.0 -86

1896994_10152943929192918_7227820895889695097_n.jpg


Started stripping the -86 down entierly to respray etc, might aswell do it properly

11061336_10152946911097918_2935305791014691230_n.jpg
 
OP
OP
Will3
Just found out that CG10DE with the 23710 99B00 ECU (which is what i have) is NIStune compatible but CGA3DE is not, so i wont be changing it for a CGA3DE.
Now i have missplaced my papers with ECU pinout :/ anyone have any good pictures?
 
OP
OP
Will3
Abit more progress, going to clean the engine of, give the valvecover som paint etc.
11666134_10152958400317918_7331709606797731916_n.jpg


Passenger side enginemount pretty much done, going to weld the little pipes on there, cut away some exess (marked) and then sandblast and paint it.
11666169_10152958582697918_1369460386079435185_n.jpg

11695535_10152958582742918_1238886519665500998_n.jpg


Facelift finished, had to modify the front as the lower headlight mountings were different. Not sure about this grille tho, maybe with the Nissan badge removed, and some work to remove the holes aswell as the cutouts for wiperarms.
11698621_10152958582867918_7718110300575087802_n.jpg
 
OP
OP
Will3
Bought a water separator for the blasting equipment today so i could blast properly, nozzle keept clogging up, then i painted the mount and moved on to blasting beltdiscs.
11659359_10152968848202918_4456297648478523016_n.jpg

10985024_10152968848292918_108132624024852731_n.jpg

Also tested the blasting media on a piece of aluminium, worked good, gets a slightly rough surface that the paint will grab onto HARD on the valvecover when i blast that.
11709999_10152969116272918_5410128140325008134_o.jpg
 
Top