N16 Almera Cupholders Bodged into a K11

I was recently looking for some March cupholders to put into me Micra but after being offered them for £50, I had other ideas, the one I followed through on was putting some Almera cupholders in. They only cost me £10 off eBay and don't actually look that bad.

First take the lower centre console to see if there is space behind, there was for me.
2 screws to take out on the side of the lcc, one in each footwell. Should just slide out after.
cuppies1.jpg


Cut off tabs otherwise it will sit uneven.
cuppies2.jpg

cuppies4.jpg

cuppies3.jpg


Aline and mark where to cut.
cuppies5.jpg


Start cutting, remember, you can always remove material but cannot add it back on, so be careful and regularly test fit and see what needs cutting and what doesn't.
My cuts look super jank because I only had a swis army knife with some blunt wood saw. Use a dremel if you have one.
cuppies6.jpg
cuppies7.jpg
cuppies8.jpg


Sand your cuts and then mark and drill 2 holes in the front for the screws.
I used a file to smoothen the edges.
cuppies9.jpg


Screw in and finish!
(yes thats plastic on the floor, yes i hoovered it, leave me alone :LOL:)
cuppies10.jpg
cuppies11.jpg


Optional, cut the top tab off. I didn't, A: couldn't be bothered, B: will hold phone or what ever else in.

cuppies12.jpg

cuppies13.jpg


Could probably fit it in below the cubby hole, but ¯\_(ツ)_/¯ too late now.

Hope this helped :)
 
Last edited:
Top