Micra K11 front crossmember?

I need to change this bit:

Vezna_stena_Niss_4bc577f7bdfbe.jpg


Is it bolted on or welded on?
 

Dougyledds

Woopa Pandastyle!
The whole front panel? i had to get a new lower crossmember cause of rust, hopefully will get my sill soon if it ever comes
 

Stani1029

Club Member
To be honest the worst part is getting it off, just a case of drilling out spot welds and chiselling it off. Once its off and all the surfaces are cleaned and straight you bolt it on then weld the rest.

Btw replace the lower crossmember not the whole front panel unless the rust has somehow got to that too
 

Dougyledds

Woopa Pandastyle!
To be honest the worst part is getting it off, just a case of drilling out spot welds and chiselling it off. Once its off and all the surfaces are cleaned and straight you bolt it on then weld the rest.

Btw replace the lower crossmember not the whole front panel unless the rust has somehow got to that too

Easy enough to replace the lower crossmember mate?
 
OP
OP
A
Another question :) Since mine is a Super S and it has antiroll bars can i swap all the Super S parts into a normal 1.0 micra including rear sway bars? Im guessing the 1.0 doesnt have these so i would need to weld them on?

DSC01657.jpg
 
Top