Manifold Question

Titch

Micra K11ng
Right, going to have a go at getting my standard manifold off, and replacing it with the fine Janspeed one that i got from Neil.
Is it hard to get the old one off and is there anything else i'll need to do/lookout for?
Titch :kungfu:
 

Ian

Ex. Club Member
dead easy to do, 14 bolts. Your car is quite new but should be ok. Watch out for the studs comming out of the head with the nut if it siezes on.
 
OP
OP
Titch

Titch

Micra K11ng
well i'm on 10 so far, and about 50 cuts on my hand. Riht, got it off the head, do i just get it off at the cat, and then put the new one in?
 
OP
OP
Titch

Titch

Micra K11ng
**** it, given up. Managed to get it off from the head, but its all ****ed up at the CAT, so will take it to a garage to do it!
 

Ian

Ex. Club Member
hmm maybe it is 12.... i was thinking it was 10 on the head, but it must only be 8. 2 on the manifold to downpipe then 2 on the cat :)
 

quickdraw

Ex. Club Member
hehe grinder is the mans best friend
 

Attachments

  • Picture 002.jpg
    Picture 002.jpg
    124.7 KB · Views: 277
  • Picture 003.jpg
    Picture 003.jpg
    122.8 KB · Views: 224
  • Picture 004.jpg
    Picture 004.jpg
    125.3 KB · Views: 272
  • Picture 005.jpg
    Picture 005.jpg
    122.1 KB · Views: 242
  • Picture 006.jpg
    Picture 006.jpg
    128 KB · Views: 233
  • Picture 007.jpg
    Picture 007.jpg
    129.1 KB · Views: 225
  • Picture 008.jpg
    Picture 008.jpg
    128.7 KB · Views: 247
  • Picture 009.jpg
    Picture 009.jpg
    123.3 KB · Views: 262
  • Picture 010.jpg
    Picture 010.jpg
    126.7 KB · Views: 232
  • Picture 011.jpg
    Picture 011.jpg
    96.8 KB · Views: 239
  • Picture 012.jpg
    Picture 012.jpg
    133 KB · Views: 235
Top