K11 (prefacelift) temperature gauge, where is the needle meant to sit?

Hi

In my daily runner K11 I noticed that my temperature gauge when warm flits to halfway, but if the blower is on warm or down motorways, if the air is cool, the needle goes down to say the lower line in the photo, then can raise back up again.

Is this normal bandwidth, or should the thermostat be keeping the needle dead halfway whatever the conditions?

Thanks
 

Attachments

  • Inkedtemp gauge_LI.jpg
    Inkedtemp gauge_LI.jpg
    42.2 KB · Views: 130
Top