Engine component torques.

davey1991

If its not scrubbing, its not low enough.
Well since its getting too the time of rebuild i need some info.

Basically need all the torques for the engine haha.

Crank bearings.
Con rod caps.
Head bolts.
everything!
 
all according to Mr. Haynes, all in lb ft

camshaft cover bolts - 2
crankshaft pulley bolt - 105
timing cover -5
timing chain tensioner bolts - 5
lower chain rear guide bolts - 5
lower chain front tensioner bolts - 12
camshaft sprocket cover bolts - 4
timing chain idler sprocket center bolt - 38
camshaft sprocket retaining bolts - 83
camshaft bearing cap bolts
stage 1 - 1.5
stage 2 - 4
stage 3 - 8
cylinder head bolts
stage 1 - 29
stage 2 - 58
stage 3 - completely slacken then to 26
stage 4 - add 60 degrees
6mm head bolts - 5
thermostat housing - 5
sump nuts and bolts - 5
sump drain plug - 25
center member bolts - 50
oil pump cover screws - 3
oil pump cover bolts - 5
regulator valve plug - 36
oil pick-up tube to timing cover - 5
oil pick0up tube support mount - 5
flywheel bolts - 65
rear oil seal/housing nuts and bolts - 5

big end bearing cap nuts
stage 1 - 11
stage 2 - angle tighten 45-50 degrees

main bearing cap beam bolts
stage 1 - 21
stage 2 - angle tighten 60-65 degrees

engine to transmission bolts (998cc)
20mm length ones - 14
60mm length ones - 26

1275 and 1348cc
16mm - 14
20mm - 14
70mm - 26

right hand engine/transmission mounting
lower bracket to engine bolts - 50
through bolt - 37
mounting upper bracket bolts - 30

left hand engine/transmission mounting
bracket to transmission - 50

through bolt - 37 (manual) or 27 (auto)

front engine/transmission mounting bolts (manual only)
mounting bracket to engine bolts - 50
mounting to center member bolts - 36
through bolt - 47

rear engine/transmission mounting
mounting to center member bolts - 50
through bolt - 41
mounting bracket retaining bolts - 50


hope that helps fella!!!!!!
 
Top