Search results

Flat screwdriver prise out the middle part then wiggle the clip free. Sent from my Mi A2 Lite using Tapatalk

And she's gone and ****ed it, stuck it in under a rav 4 Sent from my Mi A2 Lite using Tapatalk

Still no other k14s knocking about here, what's going on Sent from my Mi A2 Lite using Tapatalk

I'm pretty sure I seen a documentary about the K14 build and Renault had to really up the game to make it on their lines , So far it's build quality is as good as my 98 pulsar if not better Sent from my Mi A2 Lite using Tapatalk

Today was the first service at home for the K14 nice and straightforward just a oil and filter today. Here's whats required for anyone interested Oil 5w40 just over 4 litres Filter 15209-00Q0F Tools required Flat screwdriver for removing undertray clips 10mm socket for same An 8mm square...

Wheels fitted Sent from my Mi A2 Lite using Tapatalk

Not much happening lately got some buddy club P1s for it , fitment looks like it’s going to be good 7x17 et42 I think gives about 14mm more poke all round , sent them off for fresh powdercoat, got some yellow LED front fog bulbs and also got some LED numberplate lights. Sent from my...

No didn’t need to could get enough squeeze by hand to start the top mount retaining nut Sent from my iPhone using Tapatalk

I used spring compressors to take out the front , Sent from my iPhone using Tapatalk

18mm socket and ratchet , removed the bottom end first then worked through the little hatch Sent from my iPhone using Tapatalk

Springs fitted , should settle a little more Sent from my iPhone using Tapatalk

Sounds ok it’s no SSQV though [emoji3525] There’s the parts removed and the spare bits I didn’t use Sent from my iPhone using Tapatalk

. Very easy install, remove old recirculating valve and pipe to intake fit forge valve and block intake with the supplied hose , Iv a box of spares too vac line a 25mm hose blank and a T piece Sent from my iPhone using Tapatalk

Yeah i can do oncce i get them fitted time is hard found lately

Not yet, it hasnt arrived, the courior service has lost it for about a week They assure me it will be with me today or tomorroww . The H&R springs have arrived and will be fitted saturday this is my family car so coilovers are out of the question the pulsars getting the coilovers.

Heko wind deflectors and forge dump valve kit ordered [emoji123] Sent from my iPhone using Tapatalk

HR lowering springs ordered Negotiations started to buy back these 17” buddy clubs for it Sent from my iPhone using Tapatalk

Here’s my K14 micra , It’s a SV premium + , 0.9ig-t , and it has the orange exterior trim pack and 17” alloys with orange insert. So far it’s been nice having a new car drives nice just about enough power to get about at a reasonable pace. Iv a few mods planned a dump valve a set of lowering...

Just a small problem , I’m down to a vzr a new micra, n16van with a burst engine and a pulsar shell that both need scrapping soon Sent from my iPhone using Tapatalk

Hi all, Do we eveen have any other k14 owners here? Im planning on doing some modifications to my K14 0.9ig-t, lowering springs, H&R 35/35 there are other choices eibach/vogtland/pi/apex/direnza, as far as i recall H&R were decent on almeras anyway...