Search results

thanks fordy I Checked the protruson of the piston and it looks as if it is more than the 10mm that is suggested. looks like new chain then !!!!! What I have trouble with is why does it start with the crank sensor disconnected and sometimes normal. Also how would I "burn off" the build...

Ok all My Micra ( as posted on prvious occasions) is still poorly and all pointers lead to the cam chain stretch - although I am not 100% convinced, and heres why. 1. When i disconnect the crank sensor the car starts - a little bumpy at first try - the Engine man light flashes 3 times and...

Thanks for the advice.. This stretched chain thing really winds me up. If i disconect the crank sensor I can get the car started although it takes a little persuation to bring the revs up, once running I reconnect the plug and away it goes. Runs like a bag of ***** though, under power, use more...

Thanks for the explanation I can do this now I know where to look. Incidently would the car nort start at all if the chain ahd stretched?. I checked to reistance on the cam sensor plug pins and get readings I assume that I should get simular reading from the pins on the crank sensor ?? I did...

I have replacd the cam sensor and cleand the end plate on the cam shaft but the car will still not start. it turns over and coughs and splutters tries to start ( did actually start once) but no chance. Whne i did start the revs only went to 2800, but after a few minutes were normal and the car...

Hi all.... My ongoing saga with my K12 - fault code was p0340 cam pos sensor which i changed but still not start - engine wants to fire up but wont. changed sensor still no go - left car standing for 3 weeks - then put old sensor back on and car started albeit a little eratic. took it for a...

Identfying the engine type oK -- Cam position sensor replaced but still no change - car will not start -tries but not firing up - fuel smell but no go. looks like I have to change the chain - but how can I make sure it is the chain - theres a lot about check the protrusion on the tensioner (...

K12 03 1.0 Micra cam position sensor location Hi all you experts out there --- Thanks for those who have contributed to my issues on this subject .... So here is the next set of oportunities. Is the cam sensor on these on the top right of the cam shaft ? I have removed the rocker cover and...

oh dear Thanks for the sketch at least I know where everyting fits. Do you have a picture of the location for the cam sensor - thanks you very much

If the Fault code is showing the cam position sensor will it mean 100% that the cam chain is stretched ? I have so far removed the mounting bracket, top cover, connectors and lines etc, and now about to remove the rocker cover to inspect the "protrusion on the chain tensioner" the question is...

cam sensor thanks for your help and sugestion (Y) Frank .. So the plan should be remove the engine bracket on the drivers side - remove the gubbings from the cover and take a peek inside .. do you have or can you point me in the right direction of what I should be looking for ( pictures would...

Cam Position Sensor - k12 2003 hi folks.... been pulling my hair out for weeks now... :( baically ( depends how you look at it I suppose). Engine light cam on - car stopped and wouldnt restart - after 5 mins it did.. Garage fault displayed p0340 !!! I think but was cam position...