Search results

  1. M

    rotten drivers side sill

    Just had a look at the drivers side sill at the back and its worse than I thought. The inner part that curves and meets at the bottom has rotted out. The front part of the sill is all ok. So tomorrow I will be cleaning it all up. See if I can patch it up the old girl. Preface lifts getting rare...
  2. M

    Front shock bump stop/ bellow

    Good evening just bought some new front shock dust covers/ bellows as they have both seen better days. They are kyb part no 910031 just started stripping the drivers side tonight and they look a bit different to to stock nissan ones. I tried putting the old bump stop in the new bellows and that...
  3. M

    Sunroof woes and replacement....

    Hi just cleared the drain holes on sunroof today as I had a puddle of water on passengers side. Sods law went to close the sunroof and the plastic clip on the rear part of the glass has snapped and the curved metal piece behind it came away. Managed to shut sunroof with about 1cm left. I've...
  4. M

    Anyone have a crankshaft pulley for r reg k11 Micra(pre face lift)

    Hi just wondered if anyone has the above part lying around? My one has lost part of the metal on the outside edge when I took it off to replace the seal seems to be pretty soft metal. Failing that does anyone know where I could get one. I've done a request on a well known breaker quote site...
  5. M

    K11 Rear wheel bearing replacement

    Hi as above I'm about to replace this item over the weekend. A couple of questions when you fit the new bearing does the stub axle need a bit of grease on it prior to fitting bearing as Haynes manual doesn't mention anything about this. Secondly my torque wrench only goes up to 200Nm as the...
  6. M

    rear windscreen rubber

    My K11's rubber on the rear windscreen keeps coming off. The clip at top of the windscreen was missing when I bought the car about 2years ago and I've been pushing the rubber back on ever since! seems to be a common thing on k11's. What can you use to stick it to the glass?has anyone else had...
  7. M

    wheel alignment problems

    Hi everyone I have a preface lift k11 1.0 1997. Recently replaced the front suspension arms as one of the the ball joints was on its way out. Also did the n/s/f wheel bearing got the local garage to press it for me and I refitted the hub. All went very well. The tracking didn't feel too bad...
  8. M

    Oil gallery plug

    Morning everyone any ideas what torque the oil gallery plug would need to be tightened up to as I can't find anything in my workshop manual. I'm taking the gearbox off at the weekend. If anyone could help I'd appreciate it. Thanks Marco
  9. M

    Door glass runners

    The glass came out of the plastic runners in the door again. Cleaned it all up and used JB weld on the glass and plastic clips. In the past I've used some of that epoxy putty stuff on my other micra which works pretty good. Sprayed silicone spray in the runners and greased the bits inside up...
  10. M

    Sump leaking again

    Hi everyone just put a new clutch in last week and it's working fine. When I had a look underneath I could see a small oil leak on the transmission end behind the tin plate that sits between engine and gearbox. Cleaned everything up and it's definitely leaking from the sump can see it in the...
  11. M

    Crankshaft seal (transmission end)

    Hi I'm just changing the clutch on my k11 1.0 I found the sump was leaking at the transmission end which I've now sorted. I bought a new crankshaft seal from the Nissan dealer which measures 104mm across 84mm diameter in the middle and 8.4mm depth. When I took the old seal off its the same...
Top